Points to pay attention to after operating the pressure washer

2022-02-28 14:52:56

There are some problems that need to be paid attention to after each operation of the high pressure washer, which can prolong the service life of the high pressure washer. First, the hoses and filters need to be cleaned, because they need to be washed when they are used. There may be residues left on it. After cleaning, you can reduce the problem of corrosion. Second, you need to close the water supply system connected to the high pressure washer. Then you notice the problem of the trigger, you need to reduce the pressure inside the hose. Release them all to prevent the trigger from affecting the machine. Then there is the connecting wire of the spark plug of the bulb, to avoid the problem of starting after leaving. The above is what needs to be done after the grinding machine is used. You must pay attention to it. You must not ignore the operation after use. There are many The failure of the machine is caused by the failure of the work after the operation. After doing the above work, it can reduce the occurrence of many problems.

Why are high pressure washer nozzles easy to wear

2022-02-28 14:51:55

The nozzle of the high pressure washer is very important for emitting high pressure water, but we will find a problem, that is, the nozzle of the high pressure washer is relatively worn. Damaged nozzles can disperse the high-pressure water jet and affect the performance of the work. So what are the reasons for the wear of the nozzle of the pressure washer?

Exploration of the main application of high pressure cleaner in cleaning diameter pipes

2022-02-28 14:50:55

For the cleaning of small-diameter pipes, we often use high-pressure cleaners as the main means of clarity. Using high-pressure cleaners to clean pipes has the advantages of high cleaning efficiency, wide application range, and no pollution. In the cleaning process, due to the particularity of small-diameter pipes, the selection of main parameters such as pressure and flow rate of high-pressure cleaners will also be different. Generally speaking, small-diameter pipes are mainly affected by annular distribution and curvature, which makes their It is very different from general plane cleaning, and as the diameter of the pipe decreases, this particularity becomes more and more obvious. The following editor will introduce to you in detail what are the main factors that affect the use of high-pressure cleaners for cleaning small diameter pipes?

Things to Consider Before Using a Pressure Washer

2022-02-28 14:49:18

The small high-pressure cleaning machine uses water as the working medium. Usually, the power-driven pump completes a suction and discharge process for water, converts ordinary water into high-pressure and low-flow water, and then sends it to the high-pressure pipeline to make it run at a certain rate. The energy reaches the high pressure nozzle. The hole diameter of the high-pressure nozzle is much smaller than the diameter of the high-pressure pipeline, so the water reaching the high-pressure nozzle has to be accelerated to pass through the nozzle.